Datamax-oneil DPL Programmer’s Manual User Manual download pdf (Page 30)

System-Level Command Functions

STX n Set Printer to Imperial Mode

This command sets the printer to interpret measurements as inch values (e.g.,

<STX>c0100 will equal 1.00 inch), and is the default mode.

Syntax:

STX>n

STX O Set Start of Print (SOP) Position

This command sets the point to begin printing relative to the top-of-form (the label’s

edge as detected by the Media Sensor). The printer will feed from the top-of-form to the

value specified in this command to begin printing.

This value operates independently of the <STX>f command.

D-O recommend not using the row adjust feature instead of this command. This is a

legacy command.

Syntax:

STX>Onnnn

Where:

nnnn -

Is a four-digit offset value in inches/100 or mm/10.

The “zero” setting is the default value, and settings

below 50 are adjusted back to the default value.

The default setting is “Off” and the printer assumes

the natural SOP position.

Sample:

<STX>O0210

The sample above will begin printing 0.1 inch closer to the leading

edge of the label if the 220 (Allegro) SOP Emulation was selected,

or 1.0 inch farther away from the leading edge if 110 (ProdPlus)

SOP Emulation was selected.

STX o Cycle Cutter

This command will cause the optional cutter mechanism to immediately perform a cut

after all previously received commands are executed. The cutter must be installed,

enabled and the interlock(s) closed for operation.

Syntax:

STX>o

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 295 296

No comments

Datamax-oneil DPL Programmer’s Manual User Manual Page 30