Datamax-oneil I-Class RFID HF & UHF Option User Manual

RFID HF & UHF Option 92-2406-01 Rev.F

8Direct Mode - HF (13.56 MHz) ISO15693 Tag Interface This interface allows the Host Application to perform specific operations pertaining to HF typ

9STX KtR Read Data from RFID Tag This command instructs the RFID device to read data from the tag and then put that data into a replaceabl

10STX KtU Read Unique Serial Number from RFID Tag This command instructs the RFID device to read the unique serial number data from the tag and

11STX KtD Write Data Storage Format Identifier (DSFID) to Tag This command writes the DSFID data to the tag. Syntax: <STX>KtDabcc Where:

12Direct Mode- UHF Interface This interface allows the Host Application to perform specific operations pertaining to UHF type tags. These commands

13 STX KuE Erase RFID Tag (Alien only) This command erases the tag by filling it with nulls (0x00). Syntax: <STX>KuEa<CR> Where:

14 STX KuJ Write Data to Gen 2 Tag Section This command writes a specific block address of a Gen2 tag. Syntax: <STX>KuJaaabbb<d

15 STX KuT Send Tag ID (Alien only) This command instructs the RFID device to read data from the tag and return it to the host. This is a low leve

16Label Formatting Mode As mentioned earlier, Label Formatting mode utilizes the current printer configuration to process each tag printed. (For e

17WX / W1X: RFID with Byte Count Specifier The upper case X identifies an RFID data string with a string 4-digit length specifier, which allows v

18Option Feedback Once enabled, the printer will report information about the results of the last label printed. One response per label is returned

19Diagnostics Menu mode accesses testing functions. Press the Menu Key and scroll to DIAGNOSTICS / OPTIONS TESTING / TEST RFID.  Note: Upon se

1 CAUTION This device complies with FCC Radio Frequency exposure limits for an uncontrolled environment. This equipment should be installed

2 Installing the Option If RFID is already installed, proceed to “Programming Information”; otherwise, follow the steps below: 1. Turn o

3 4. Route the RFID Cable, as shown, then connect the cable to the connector in the Centerplate. This completes the installation. Load Smart

4 Initialization The initialization interface to the RFID module is auto baud detectable by the printer. Commands necessary to enable, configure, r

5Data Input Data Input is in the form of System and Label Formatting commands, where <STX>KcRI and <STX>KcQQQ support the entries that

6<STX>KcOFa configures the printer to output the status of the RFID operation, as noted below: Value Range / Interpretation D, Rx, S D -

7 c - Command 1. Reserved for Future (should be 0) d - Command 2. Reserved for Future (should be 0) ee…e - Data to be encoded on RFID tag (H