Datamax-oneil M-Class Mark II DMXNet III Card Option User Manual

DMXrfNet III and DMXNet III Card Option 92-2595-01 Rev.A

Printer’s Internal Web Pages 8 Printer’s Internal Web Pages 1. Open your web browser. Type in the IP Address of the printer. The Default IP is:

Printer’s Internal Web Pages 9 GENERIC NETWORK CONFIGURATION Page NETWORK INTERFACE NETWORK INTERFACE Selects WIRED ETHERNET (802.3) or WIRELESS

Printer’s Internal Web Pages 10 WIRED ETHERNET CONFIGURATION Page DHCP ENABLED/DISABLED Controls IP Address discovery, where: ENABLED: Broadca

Printer’s Internal Web Pages 11 DMXrfNet3 Page (continued…) ADHOC CHANNEL ADHOC CHANNEL When Wireless Network Type is Ad Hoc, selects the channel

DMXConfig 12 DMX Config Utility DMXConfig (located on the Accessories CD-ROM) is a Windows based configuration utility that allows the user to mak

Installing the Printer Driver 13 Installing the Printer Driver The following screen shots are taken from Windows 2000, other versions will be sim

Installing the Printer Driver 14 9 Insert the Accessories CD-Rom and click ‘Browse’. 10 Browse to the “\DRIVERS\Seagull” folder on the CD-ROM, m

Additional Information 15 Wireless and Wired Ethernet Specifications The following list and table describes the key features and specifications of

Card Installation 1 This document describes the installation and use of the DMXrfNetIII and DMXNetIII Card options for the M-Class Mark II printers

Card Installation 2 Preparing the Printer (continued) 4. Open the cover, loosen or remove the two Screws from the inside of the printer as shown.

Card Installation 3 Installing the Communication Card 1. Insert the two supplied Standoffs into the printer’s Main Board as shown. StandoffsMa

Overview 4 Introduction The M-Class MarkII series of printers are available with two Communication Card options. These cards can be equipped in t

Network Setup 5 Network Card Reset It is recommended that the printer’s communication settings be reset to factory defaults to avoid any conflicts

Network Setup 6 Network Card Setup - Wireless (Infrastructure Mode) After a successful setup is made via a wired connection, the Wireless conn

Network Setup 7 Network Card Setup - Wireless (Adhoc Mode) To configure the wireless card in Adhoc mode, you must configure your host computer