Datamax-oneil S-Class User Guide User Manual download pdf (Page 56)

48 S-Class

4.4.6 Exterior Cleaning

When necessary, the exterior surface can be cleaned using a general

purpose cleanser and a soft cloth or sponge. Clean printers exterior

covers as follows:

 Turn ‘Off’ and unplug the printer.

 Gently wipe the exterior surfaces until clean and then allow time to

dry.

 Plug in and turn ‘On’ the printer.

CAUTION

NEVER use abrasive cleansers or solvents. NEVER spray

cleansers into the printer or allow over-spray to get on internal

components, such as the printhead. Damage can result.

4.4.7 Downloading Firmware and Fonts

The operating programs and fonts for the printer are stored in Flash memory on

the Main PCB. When program updates and/or new features are added, they can

be downloaded to the printer as follows:

Identify the new version for your model of printer from the Datamax-

O’Neil Web site at www.datamax-oneil.com and download it onto your

computer’s hard drive or a floppy disk.

2. Ensure that the printer is connected to the host, (via parallel port only) and

that the power is ‘On.’ Using the DOS copy command enter:

copy filename.dlf lpt1/b

(non-display printer firmware is .dlf extension)

copy filename.zs lpt1/b

(display printer firmware is .zs extension)



Note: Other programs (e.g., hyper-terminal and certain Windows

Driver programs) may also be used to download this file.

3. The ON-LINE light will flash during the download.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 91 92

No comments

Datamax-oneil S-Class User Guide User Manual Page 56