Datamax-oneil S-Class User Guide User Manual download pdf (Page 36)

28 S-Class

4.0.1 ST Model Media Sensor Adjustment

The ST Model can be equipped with either a Standard or a Print Side

Media Sensor. Follow the appropriate procedure for the Media Sensor in

your printer:

Adjusting the Standard Media Sensor –

 Turn ‘Off’ the Power Switch. Open the Access Cover.

 Loosen the Thumbscrew and adjust the Media Guides to fit the width

of the ticket stock:

The guides should be positioned so that there is no side-to-side ticket

movement (too loose), but not so close as to cause friction or bowing

of the ticket (too tight). (See Step 5 in Section 3.2.1 for an

illustration).

Once properly positioned, tighten the Thumbscrew to secure the

Media Guides in place.

 Unlock the Printhead Latch and raise the Printhead Assembly.

 Grasp the Slide to move the Media Sensor. Position the sensor so

that it can see the Quiet Zone and the TOF Marks on the ticket stock,

as described in Section 4.0.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 91 92

No comments

Datamax-oneil S-Class User Guide User Manual Page 36