Cutter Option 92-2421-01 Rev.B
1 Overview This document describes the contents, installation, and use of the Cutter option for the H-Class printer. After verifying the contents
2 B) Press down on the Catch, then pull forward to remove the Door. DoorCatch C) Raise the Access Cover and remove your media fr
3 Step 3: Using the Option During operation, cut labels will be dispensed after printing. Begin using the option as follows: A) Load Media (s
4 Step 4: Configuring the Printer While the Cutter option is a plug and play device, this step may be necessary if the printer’s default configu
5 Maintaining the Cutter To ensure trouble free operation, the Cutter should be cleaned after printing each roll or box of labels. Additionally,
6 4. Close the Cover, then reinstall and tighten the Cover Screw. 5. Carefully press the Cutter Assembly into the Front Plate Connector and, usin
7 Cutting Requirements Table 1, below, lists the media requirements for use with the cutter option. For a complete listing of media requirements, s
Comments to this Manuals